062509 - Laserfiche WebLink

Browse Search

6. Provide equipment and materials to remove debris from jobsite. 7. Provide equipment and materials to off load equipment at jobsite per scheduled delivery. 8. Provide any necessary permitting. 9. Ground the new product on poles per the NFPA 780 code. This will include grounding of the electrical enclosures and remote light fixture cross arms. 10. Install Musco electrical enclosures and fixtures on existing poles and terminate power feed. 11. Provide materials and equipment to wire and terminate ballast to SCG fixtures. 12. Provide materials and equipment to install all new underground conduit, new wiring, new pull boxes etc. and terminate wiring to existing poles. 13. Provide materials and equipment to upgrade existing electrical service panel from 200 to 250 amp and any other electrical upgrading as necessary. 14. Contractor will commission Control Link by contacting control -Link Central (877-347- 3319) and going through the following steps: 15. Check all zones to make sure they work in both auto and manual mode. 16.1 hour comprehensive burn of the lights on each zone. 17. Set baseline for the DAS (Diagnostic Acquisition System). 18. Keep all heavy equipment off of playing fields. Repair damage to grounds, which exceeds that which would be expected. Indentations caused by heavy equipment traveling over dry ground would be an example of expected damage. Ruts and sod damage caused by equipment traveling over wet grounds would be an example of damage requiring repair. 19. Jobsite to be returned to condition existing prior to construction of lighting system. 20. Locate existing underground utilities and confirm irrigation systems have been located so as to avoid damage from construction equipment. Repair any such items damaged during construction. HILLCREST CENTER 403 WEST HILLCREST DRIVE, THOUSAND OAKS, CALIFORNIA 91360-4223 (805) 495-6471 FAX: (805) 497-3199 E-MAIL:parks@crpd.org